yzf r125 yardımmm (çalışmıyor)

Katılım
31 Ocak 2014
Mesajlar
123
572yAA.jpg
[/url][/IMG] arkadaşlar motor uzun suredır çalışmayan bir motor normal marşa basınca tık tık ediyor çalışmıyor akü boşalması çok normal bende vurdurmak istedim fakat yinede vurdururken tık tık yapıyo marş almıyo bi kaç kez denedim yinede olmadı ve fotoğraftaki sarı motor işareti yanıp sönüyor sorunun ne olduğunu bilen varmı ve sizce bu sorunun maliyeti ne olur ? şimdiden saolun
 
Katılım
14 Nis 2015
Mesajlar
32
Sarı ışık kaç defa yanıp sönüyor? hata kodu ona gore okunuyormuş. uzun yanım sonme sayısı ilk hane, kısa yanıp sonmeler 2. hane olucak şekilde şöyle bir liste buldum:

12 Crankshaft position sensor
No normal signals are received from the crankshaft position sensor.

13 Intake air pressure sensor
(open or short circuit) Intake air pressure sensor: open or short circuit
detected.

14 Intake air pressure sensor
(hose line) Intake air pressure sensor: hose system malfunction
(clogged or detached hose).

15 Throttle position sensor (open or short circuit)
Throttle position sensor: open or short circuit detected.

16 Throttle position sensor Stuck throttle position sensor detected.
21 Coolant temperature sensor
Coolant temperature sensor: open or short circuit detected.

22 Intake air temperature sensor
(open or short circuit)
Intake air temperature sensor: open or short circuit detected.

30 Lean angle sensor (latch up
detected)
The vehicle has overturned.

33 Ignition coil (faulty ignition)
Malfunction detected in the primary wire of ignition coil.

37 ISC valve (stuck fully open) Engine speed is high when the engine is idling

39 Injector (open circuit) Injector: open circuit detected.
41Lean angle sensor (open or short circuit)
Lean angle sensor: open or short circuit detected.

42 Speed sensor
No normal signals are received from the speed sensor.

43 Fuel system voltage (monitoring voltage)
The ECU is unable to monitor the battery voltage (an
open or short circuit in the line to the ECU).

44 Error in writing the amount of CO adjustment on EEPROM
Error is detected while reading or writing on EEPROM
(CO adjustment value).

46 Vehicle system power supply (Monitoring voltage)
Power supply is not normal.

50 ECU internal malfunction (memory check error)
Faulty ECU memory. (When this malfunction is
detected in the ECU, the fault code number might not appear on the meter.)
 
Katılım
31 Ocak 2014
Mesajlar
123
Sarı ışık kaç defa yanıp sönüyor? hata kodu ona gore okunuyormuş. uzun yanım sonme sayısı ilk hane, kısa yanıp sonmeler 2. hane olucak şekilde şöyle bir liste buldum:

12 Crankshaft position sensor
No normal signals are received from the crankshaft position sensor.

13 Intake air pressure sensor
(open or short circuit) Intake air pressure sensor: open or short circuit
detected.

14 Intake air pressure sensor
(hose line) Intake air pressure sensor: hose system malfunction
(clogged or detached hose).

15 Throttle position sensor (open or short circuit)
Throttle position sensor: open or short circuit detected.

16 Throttle position sensor Stuck throttle position sensor detected.
21 Coolant temperature sensor
Coolant temperature sensor: open or short circuit detected.

22 Intake air temperature sensor
(open or short circuit)
Intake air temperature sensor: open or short circuit detected.

30 Lean angle sensor (latch up
detected)
The vehicle has overturned.

33 Ignition coil (faulty ignition)
Malfunction detected in the primary wire of ignition coil.

37 ISC valve (stuck fully open) Engine speed is high when the engine is idling

39 Injector (open circuit) Injector: open circuit detected.
41Lean angle sensor (open or short circuit)
Lean angle sensor: open or short circuit detected.

42 Speed sensor
No normal signals are received from the speed sensor.

43 Fuel system voltage (monitoring voltage)
The ECU is unable to monitor the battery voltage (an
open or short circuit in the line to the ECU).

44 Error in writing the amount of CO adjustment on EEPROM
Error is detected while reading or writing on EEPROM
(CO adjustment value).

46 Vehicle system power supply (Monitoring voltage)
Power supply is not normal.

50 ECU internal malfunction (memory check error)
Faulty ECU memory. (When this malfunction is
detected in the ECU, the fault code number might not appear on the meter.)

valla çok saol uğraşıp bulmuşun ama anlamadım fazla :D sorun bence aküde değilmiş gibi geliyor çünkü tık bile yok marşa basınca vurduruncada çalışması lazımdı ama marş almadı sarı ışıkta sadece vurdurmaya çalışınca yanıp sönmeye başlıyor ayrıca
 
Katılım
16 Ara 2015
Mesajlar
185
Hocam marşa basınca farlar sönükleşiyor mu? R125te varmıdır bilmiyorum ama bazı modellerde akü belli bir montajın altına düşünce vurdursanız bile ECU enjektör ve bujilere akım vermeyeceğinden çalışmaz... Aküyü tekrar şarj edip denemenizde fayda var. Bir de uzun süre derken ne zamandır yatıyor motor?
 
Katılım
31 Ocak 2014
Mesajlar
123
Hocam marşa basınca farlar sönükleşiyor mu? R125te varmıdır bilmiyorum ama bazı modellerde akü belli bir montajın altına düşünce vurdursanız bile ECU enjektör ve bujilere akım vermeyeceğinden çalışmaz... Aküyü tekrar şarj edip denemenizde fayda var. Bir de uzun süre derken ne zamandır yatıyor motor?

valla nerdeyse 6 aydır yatıyor motor dediğiniz gibi yapıcam aküyü şarj edicem birde öyle denerim çalıştırmayı fakat normal dururken farlar falan cok iyi yanıyor uzunlar falanda süper aydınlatıyor yinede dediğinizi dinlicem saolun
 

Bu konuyu görüntüleyen kullanıcılar

Çok Beğenilen Mesajlar

Üst